If you want a drop in gold kitchen sink but don’t have the skills to cut granite yourself, it may be worth hiring a contractor to do the job. A granite fabricator can cut the sink to fit the hole in the countertop, or they can match the existing cutout and attach the new sink. While it’s possible to cut granite yourself, this process can be time-consuming and costly.

If you’re a do-it-yourself type, installing a drop-in sink onto a granite countertop is fairly straightforward, but you’ll need to take a few extra steps to ensure that it looks professional. For example, you should check the installation manual for the sink you’ve chosen. Alternatively, you could get a friend or family member to assist you.

Need to drill holes

Once you’ve marked where you’d like the sink to go, you’ll need to drill holes for the mounting clips. To do this, use a 1/4-inch drill bit. Then, use a rubber headed hammer to tap the sink insert into place.

You’ll also need to measure the hole in the granite countertop. The opening should be 33×22 inches, and you’ll need to be sure that the new sink will fit. If you’re unsure of the size of your granite countertop, it’s best to get a sample piece first.

Use caulk

The next step of the installation process involves connecting the plumbing underneath the countertop, which is mostly located underneath the cabinet. Afterward, you’ll need to caulk around the sink to ensure that the seal is watertight and that there’s no chance of leaks. Once the sink is in place, you can move on to installing the faucet and drain.

Use a jigsaw

To cut the hole, you can use the same technique as for granite countertops, but you may want to use a jigsaw. In case you’re working with laminate countertops, remember that you need to cut the hole from the top instead of the bottom, as cutting from the bottom can cause the laminate to chip outward. Also, make sure that you use a jigsaw for curved surfaces. In addition, you can use a spade bit to cut a circular hole at the edge of the cutout.

While installing drop-in sinks is relatively easy, it’s important to note that you’ll have to make certain adjustments to your countertop before installing them. Depending on the type of sink you’re installing, you might need to cut a hole for the faucet. Masking tape is a great way to prevent mistakes and to ensure clean cuts. If you need to make larger cuts, you can use an angle grinder to cut the holes. In case of smaller holes, you can use a diamond drill bit to drill the faucet holes. You should also use silicone to ensure that the countertop and sink are stuck together and prevent mold growth.

Before installing the sink, you must carefully measure the opening for the new sink. Once you’ve cut the hole for the sink, you can epoxy-bond the countertop to the sink. If you’re installing a granite countertop, you’ll need to make sure that the sink is placed correctly. To do this, you will need to prepare your countertop.