If you’ve been wondering how to take shower Nivito head off, there are several easy steps to follow. First, you should unscrew the escutcheon plate that covers the hole in the wall that leads to the valve body. The escutcheon plate is also known as the trim plate. Taking it off before replacing the handle will prevent you from damaging the O-rings.

Vinegar is a great way

Vinegar is a great way to clean hard water deposits and rust from faucet spray heads. It also has natural cleansing properties, which can help remove stubborn buildup. It’s also good for removing stains and odors. For the best results, make sure to use the solution in a well-ventilated area.

Once you’ve removed the handle, you need to clean the inner parts. If necessary, you can use lemon juice or distilled white vinegar to remove mineral deposits. Next, you need to remove any screws attached to the shower handle. Then, you’ll need a screwdriver or a hammer to pry the handle off. Once the handle is free, you can pull out the cartridge. If the cartridge is damaged, you can use a pair of needle pliers to gently remove it.

Use toothbrush

You can also use a toothbrush to clean the aerator screen. If the screen is clogged, it will prevent water from flowing freely. To clean the aerator screen, you can also use a soft-bristle brush. Afterward, make sure to close the drain before you do anything else.

Usually, the aerator screw is threaded on the inside and can be unscrewed by hand. To remove it, you need to be dry and have pliers on hand. If the aerator is stuck, you may need to move the pliers a quarter turn around the aerator. However, you must be careful not to bend it or you’ll make the job harder.

Clean the showerhead

Another way to clean the showerhead is to use vinegar. Vinegar is good at dissolving limescale deposits. You can also add baking soda to the solution. Then, you can reattach the showerhead. During this process, you should also apply new plumbing tape to ensure a tight seal.

If you’re unable to remove the old showerhead, you can also use a penetrating lubricant to loosen the connector. Liquid Wrench or WD-40 will work well. Before removing the shower head, use a cloth to wipe away any gunk or hard water buildup.